Glossary

• Fibre Most mattresses will have layers of fillings under the surface to increase comfort and separate the spring units from the surface. The most common fillings used in mattresses are cotton, wool and polyester among others. Mattresses require fillings to create a soft surface tension on which to sleep. The fillings normally compliment the internal spring unit by adding comfort to the support offered (by the spring unit) The tension of the surface fillings can be tuned by the density in which they are packed as well as by the method in which they are bound together. Tufting results in a slightly firmer feel than quilting.
• Hideaway (Hypnos)

  Hypnos have created the ingenious Hideaway bed base. A design that gives you the maximum amount of storage space from the base, whilst remaining completely hidden.

• Hypoallergenic

  Put simply, Hypoallergenic materials do not cause the amount of irritation that non-hypoallergenic materials can. Hypoallergenic materials can still cause irritation in some cases, the chances of this are reduced greatly. People with severe allergies and asthma may still have problems with items called hypoallergenic, but the risk is greatly reduced.
  
  Hypoallergenic materials do not omit the same particles and fibres as other non-hypoallergenic materials. These particles are to blame for causing irritation and discomfort and in some cases the irritation can be dangerous. The Hypoallergenic properties of these materials can be created by number of techniques. Some materials (Memory Foam or Latex) are naturally hypoallergenic, others have been chemically treated.

• Pocket Sprung

  Pocket Sprung units are an adaption of the traditional open coil/continuous spring unit. By placing each spring in its own individual 'pocket' (a fabric sock-like pouch), the spring is not joined to any other part of the mattress. The pocket that supports the spring is then joined to its neighbouring pockets and this effect creates a unique feel.
  
  By creating a spring unit in this way, it allows the springs to move independently, rather than sharing the pressure with surrounding springs. This effect allows for much more accurate contour following and a more comfortable feel overall.
  
  If you were to push your hand into a traditionally sprung mattress, the area around your hand would dip/sink too. With Pocket Springs, this sunken area is much more remote and therefore more accurately follows the contours of the pressure source. There are differences in the techniques used to create Pocket Springs, but more or less they remain the same.

• Tufted

  Tufting is a traditional and highly successful way of finishing a mattress surface. The end result makes the mattress appear to have dimples, or buttons dipping into the surface. This technique is designed to hold the surface materials together and to fix them to the core of the mattress to prevent the layers moving over time. A modern method is Spiral Tufting, which involves fixing the surface to the fillings and spring unit.
  
  The actual tuft is usually made from a cotton felt material and is fastened by a cotton or wool chord to the spring unit, in most cases. A tufted mattress will normally have a firmer surface than a non-tufted/quilted surface. The reason for this is that the Tufting process actually holds the surface material and underlying fibre layers tightly together. This will create a tighter, firmer feel than a quilted mattress.

• Turn / No Turn

  Some mattresses require turning over, to aid even settlement. Others do not require turning, but will still require rotating.

• UltraSens (Hypnos)

  Similar to the ReActive spring, but further refined. The UltraSens has more Turns (see above) and has a slightly softer finish on the extreme ends of the spring.