Sealy Ashton Mattress

Glossary

• Breathability

  Mattresses need to breathe. With the amount of fillings and areas of space within a mattress, they can quickly hold heat and moisture. Over time this can influence the way a mattress behaves and also effect the life span of a mattress. 
  
  Manufacturers have developed different ways of tackling the problem of Breathability in mattresses. Some brands have used vents to allow air to pass through the mattress. Some brands use state-of-the-art materials to cover the mattress, such as Coolmax or Outlast. Memory Foam has a reputation of storing heat and moisture, as foam requires heat to soften up.Memory Foam brands have overcome this problem by applying Coolmax and Outlast, they also use Open Cell technology. This technique is to simply allow the foam to settle with larger spaces between the foam cells. This allows heat and moisture to move freely without getting trapped.
  
  Some mattresses are created in such a way that they do not require any additional Breathability methods. These mattresses are generally the entry level mattresses with Open Coil spring units and not a great deal of fillings.
  
  

• Pocket Sprung

  Pocket Sprung units are an adaption of the traditional open coil/continuous spring unit. By placing each spring in its own individual 'pocket' (a fabric sock-like pouch), the spring is not joined to any other part of the mattress. The pocket that supports the spring is then joined to its neighbouring pockets and this effect creates a unique feel.
  
  By creating a spring unit in this way, it allows the springs to move independently, rather than sharing the pressure with surrounding springs. This effect allows for much more accurate contour following and a more comfortable feel overall.
  
  If you were to push your hand into a traditionally sprung mattress, the area around your hand would dip/sink too. With Pocket Springs, this sunken area is much more remote and therefore more accurately follows the contours of the pressure source. There are differences in the techniques used to create Pocket Springs, but more or less they remain the same.

• Pressure Points

  Pressure Points are created in the body when lying on a mattress which is not suitable for a persons physique. The Pressure Points are caused by putting stresses through the body. When the spine is not aligned correctly (i.e, straight), it can cause pressure to build up in the back, hips or shoulders (etc).
  
  When a bed is too soft, the body sinks in, causing certain areas to be under the strain of the rest of the body. When a mattress is too hard/firm, then the weight applied can cause the body to flex/bend in the opposite way - causing a similar problem. Hips, shoulders and so on, are requried to be sunken into the mattress slightly more than the surrounding areas, as they carry the weight. When this is not the case, the lower back may be bent to compensate. The ideal mattress is one which will keep the spine straight.

• Turn / No Turn

  Some mattresses require turning over, to aid even settlement. Others do not require turning, but will still require rotating.